Korpus Kolink KLA-002 black

Tootekirjeldus inglise keeles: Kolink has now established a solid reputation for high-quality but reasonably priced housings. Now comes the extremely chic Midi-Tower KLA-002 . Almost a special feature, this case has two externally accessible 5.25-inch shafts. The front is made of high quality plastic with the stylish look of brushed aluminum. In the tidy interior of the KLA-002 is plenty of space for hardware and also plenty of space for water cooling and practical cable management are just some of the highlights of this, despite its high-quality workmanship inexpensive housing by Kolink.The features of the Kolink KLA-002 RGB at a glanceDesign housing for motherboards up to ATX1x pre-installed 80 mm fan on the backI / O Panel with 2x USB 2.0 / 1x USB 3.0 & HD Audio In / OutSupport for a radiator in 240 mm format3x 3.5 and 2x 2.5 inch disk slotsGraphics cards up to 35 cm in length & CPU cooler up to 15 cm in heightAmple space for hardware and two 5.25-inch drive baysThe solid chassis is made of one-millimeter thick SECC steel and has a stylish plastic front with a brushed aluminum look. The power supply is mounted at the top back, while the front under the HDD cage with space for up to two hard drives. Another HDD can be installed on the back wall of the mainboard tray. Alternatively, two 2.5-inch SDDs can be accommodated there. There is also enough room for cable management. Meanwhile, slots for 5.25-inch drives in enclosures have become a rarity. The KLA-002 brings two of them. This makes fan controls or optical drives accessible from the outside. To ensure the ventilation of the installed hardware, a pre-installed 80 mm fan is already installed, which removes the waste heat from the spacious housing. There are two 120mm fans on the front. If you prefer a water cooling system instead, you can install a 240 mm radiator here. Generous ventilation slots on the front cover ensure that enough fresh air gets inside the case. An 80 or 120 mm fan can also be attached to the left side panel. Pixel cars may be up to 35 inches long and CPU cooler up to 15 inches high. In addition, the front panel I / O panel has two USB 2.0 ports and a USB 3.0 Type A port . Technical details:Dimensions: 175 x 350 x 410 mm (W x H x D)Material: steel, plasticWeight: about 3.5 kgColor: BlackForm factor: ATX, Micro-ATX, Mini-ITXTotal possible fan: 2x 120 mm (front) 1x 80/120 mm (side panel) 1x 80 mm (rear)Pre-installed: 1x 80 mm (back)Radiator mountings: 1x 240 mm (front)Drive bays: 3x 3.5 inches (internal) 2x 2.5 inches (internal)Power supply: 1x standard ATX up to 160 mm (optional)Expansion Slots: 7I / O-Panel: 2x USB 2.0 (internal connection) 1x USB 3.0 (internal connection) 1x per Audio In / OutMaximum graphics card length: 350 mmMaximum CPU cooler height: 150 mm