Alphacool Vesijahutus Eisbecher Lite 250mm Acetal (15196)

Reinvent the tube The Eisbecher Series consist of 20 different reservoirs that differ between usage, measurement and appearance. There are ten reservoirs within this series that consist of 99% plexi - totally unique! But the main difference between these reservoirs is within the functionality of the different sockets. Constituents Bubble DownIt is placed at the bottom of the reservoir to prevent turbulences that could lead air into the watercircle. Lighttower StandpipeThe "Lighttower" effect creates an astounding visual experience within every watercooling system. The Eisbecher supports this in two different ways: fluid coming from the bottom and coming from the top. The water is being led through the standpipe to the bottom or to the top where it splashes out of eight evenly distributed holes at the end of the pipe to the inner wall of the reservoir. This special watergame is the so called "Lighttower" effect. StandThe known feet from the "Eisdecken" find its very way even to the Eisbecher and sustain every combination with a solid stand. MountingsThere are two mountings placed above and under the pipe for fastening the lot in the casing. The holes in this mounting have a spacing of a 120/140 cooling fan.You can reduce the width of the mountings up to the width of the reservoir and there are three M4 threads availaible per mounting for fastening if you would rather not mount the reservoir at the fan space. These mountings are easily removeable especially when not being used. You will find these mountings on all 20 reservoirs. Lighting moduleThe lighting modules consist of plexi and enable the lighting with a 5mm LED. These modules can be installed into all 1/4" holes. They are being used in the lid and occasionally in the socket of the reservoir. This facilitates a unique way to your personalised lighting effects. MaterialAll models of the reservoir are availaible in acetal and plexi. So there is something for everone. Measurements All reservoirs are availaible in two different sizes: the 150mm version and the 10cm bigger 250mm version. The smaller reservoir comes with only one standpipe coming from the bottom because of its size and the bigger reservoir comes with two: one coming from the top and the other one from the bottom. The Eisbecher Lite This reservoir is being operated with a seperate pump as well but it slightly differentiates itself from its other four siblings. Instead of the Bubble Down and the standpipe Alphacool has installed a bar in the middle that intercepts all turbulences of the water. Further, this bar with the Alphacool Logo in the Plexi version can be lighted with three LEDs - a true eyecatcher for every system. But you do not have to go without the Lighttower effect here as there is a small standpipe mounted in the top.The openings to fill or drain the liquid are doubled here: One at the side and one at the bottom. Included in delivery: 8x M4x8mm screw 4x M4 nut 2x G1/4" locking screw 1x allen key 2,5mm Measurements 250mm Version:Measurements with mounting (LxWxD): 251 x 136 x 80mmMeasurements without mounting(LxW): 251 x 60mm Diameter of the Plexitube: 60mm Capacity: 360ml Download 3D-file (.stp)