Alphacool Eiswolf 2 AIO - 360mm RX 7900XTX Merc 310 with Backplate

The Alphacool Eiswolf 2 is the first full cover GPU AIO waterblock from Alphacool. It is based on the Alphacool GPX Eisblock Aurora GPX water block, a pump unit and a 360mm NexXxoS ST30 full copper radiator. The latter is equipped with the Alphacool Aurora Rise Digital RGB fans.Fullcover Waterblock?The Eiswolf 2 graphics card AIO water block not only cools the GPU with liquid but also all relevant components that require active cooling. This includes the graphics memory, the VRM and, if necessary, other components that require direct cooling. By using the Eisblock GPX Aurora water cooler, the cooling capacity is identical to that of a DIY graphics card water cooler.Chrome-plated copperThe cooler is made entirely of chrome-plated copper. A chrome plating is much harder than a nickel plating and therefore less sensitive to acids, scratches and damage. It completely eliminates the risk of chipping nickel plating. Additionally, chrome plating looks much more homogeneous and provides a shine that cannot be achieved by nickel plating. Chrome-plated coolers have previously only been used in the industrial sector in areas where extreme influences act on the coolers.PumpThe Eiswolf 2 has a pump unit in place of the normal connection terminal. This pump unit houses the DC-LT 2 pump. An improved and quieter version of the well-known DC-LT Low Noise Ceramic Pump. Despite looking rather large, the pump unit is only 5 mm wider than a normal connection terminal.Fittings and TubingAs with all new AIO units, Alphacool uses only TPV hoses from the Enterprise Solution range for (usually reserved for servers and workstations) in the Eiswolf 2. The tubing is made of EPDM/PP and are extremely heat-resistant, durable, and free of plasticizers. All fittings are also based on the Enterprise Solution range and match the TPV hoses perfectly.ExpandabilityBy using the quick-release fastener, the Eiswolf 2 can be connected to another Alphacool AIO unit to achieve a larger loop in seconds. Alphacool offers various prefilled components with which the loop can be easily extended. For safety reasons, the quick-release fasteners are firmly screwed together and not just plugged together.Lighting and fansThe Eiswolf 2 cooler has a digital RGB LED lighting, also called addressable RGB LEDs. They run along the entire back of the graphics card cooler and provide complete illumination of the water cooler. The pump unit is more discreet and offers a green glowing logo for Nvidia and a red glowing logo for AMD cards. The name "Eiswolf" on the pump unit remains unlit, discreetly in the background. The fan used is the Aurora Rise with 120mm. Due to the special blade design, the fan is extremely quiet and the addressable RGB LEDs provide brilliant illumination. The Alphacool Aurora Rise fan convinces with a max. static pressure of 3.17mm/H2O and offers a max. air flow of 119.8m3/h. The PWM control allows the fan to be controlled over a wide speed range. In addition, it offers a zero control. It can therefore be regulated down to 0 rpm and then starts with approx. 350 rpm.NexXxoS RadiatorAs with all AIO units, Alphacool uses radiators from the world renowned NexXxoS series. The full copper radiators offer a much higher cooling capacity than aluminium radiators and have contributed significantly to Alphacool's worldwide success.The combination of all of the components results in a solution that is as simple as an AIO solution to install, but with the performance of a pre-assembled and prefilled custom loop.Technical note!Due to long storage times and various transport routes, the liquid in the Eiswolf 2 AIO remains still for a long time. The ingredients of the liquid can therefore deposit and lead to a brownish discoloration. As soon as the pump starts operating, the ingredients mix again and the liquid should regain an approximately clear color. This is not a reason for complaint as neither the performance nor the function of the AIO are restricted by this. If the discolouration of the cooling liquid does not disappear after the AIO has been put into operation, please contact our support team via E-Mail (info@alphacool.com). You will receive quick and uncomplicated help there. Compatibility:- XFX Speedster MERC 310 Radeon RX 7900 XT Black Edition, 20GB GDDR6 (RX-79TMERCB9)- XFX Speedster MERC 310 Radeon RX 7900 XT, 20GB GDDR6 (RX-79TMERCU9)- XFX Speedster MERC 310 Radeon RX 7900 XTX Black Edition, 24GB GDDR6 (RX-79XMERCB9) Technical data radiatorDimensions (L x W x H)395 x 124 x 30mm (+/- 3%)Material cooling fins, chambers & channelsCopperMaterial threadsBrassMaterial outer housingstainless steelG 1/4“ threads2 x for tubes (+ 1x Fillport G1/4“)For fan size120 mmOptions for fan assembly3 x one-sided / 6 x both-sidedTechnical data cooler and pumpDimensions (L x W x H)287,10 x 145,00 x 71,43mmMaterial cooler bottomChrome plated copperMaterial cooler topacrylicThreads2 x G1/4“Pump typeDC-LT 2Pump speed2600 rpm (+/- 10%)Head of delivery1 mMaximum flow rate72 L/hVoltage6-13.5V DCPower consumption3.2WMTBF50.000 hTechnical data liquidColorclearIngredient 1Destilled water (CAS-number 7732-18-5)Ingredient 2Glysantin (CAS-number 1017-21-1)Working temperatures-15 C° / +90 °CTechnical data quick fastenersDimensions (L x D)95 x 27mmMaterialNylonFor tube size12,7 / 7,6mmColorBlackTechnical data fittingsL x D straight fitting24 x 18mmQuantity straight fittings2xL x B x H 90° fitting35 x 27 x 17mmQuantity 90° fittings2xFor tube size12,7 / 7,6mmMaterial fittingsBrassTechnical data tubeLength50cmMaterial tubeTPV (EPDM/PP)ColorMatt blackTube size12,7 / 7,6mmHardness grade35 Shore-A to 50 Shore-DWorking temperature-50 to +155 °CTechnical data fanSpeed0 - 2500 RPMStatic pressure3,17 mm H2OAir flow rate119,8 m³/hBearingsSleeve bearingFan connector4-Pin PWMConnection Digital aRGB3-Pin JST + 3-Pin 5VDimensions (L x W x H)120 x 120 x 25mmNet weight187gMax working temperature60°C