Võrguseade MOXA 1-portiga Modbus RTU/ASCII/TCP/IEC 101-to-IEC 104 gateways, -40 to 75°C

Protocol conversion between Modbus RTU/ASCII/TCP, IEC 60870-5-101, and IEC 60870-5-104Supports IEC 60870-5-101 master/slave (balanced/unbalanced)Supports IEC 60870-5-104 client/serverSupports Modbus RTU/ASCII/TCP master/client and slave/serverEffortless configuration via web-based wizardStatus monitoring and fault protection for easy maintenanceEmbedded traffic monitoring/diagnostic information for easy troubleshootingmicroSD card for configuration backup/duplication and event logsBuilt-in Ethernet cascading for easy wiringRedundant dual DC power inputs and relay output-40 to 75°C wide operating temperature models availableSerial port with 2 kV isolation protectionSecurity features based on IEC 62443, Introduction The MGate 5114 is an industrial Ethernet gateway with 2 Ethernet ports and 1 RS-232/422/485 serial port for Modbus RTU/ASCII/TCP, IEC 60870-5-101, and IEC 60870-5-104 network communications. By integrating commonly used power protocols, the MGate 5114 provides the flexibility needed to fulfill the various conditions that arise with field devices that use different communications protocols to connect to a power SCADA system. To integrate Modbus or IEC 60870-5-101 devices onto an IEC 60870-5-104 network, use the MGate 5114 as a Modbus master/client or IEC 60870-5-101 master to collect data and exchange data with IEC 60870-5-104 systems. Easy Configuration via Web Console The MGate 5114 Series comes with an illustrated Quick Setup guide designed to make configuration easy. With Quick Setup, you can easily access protocol conversion modes and finish the configuration in a few steps. Modbus RTU/ASCII/TCP Protocol Traffic Monitor MGate 5114 Series gateways support Modbus RTU/ASCII/TCP, IEC 60870-5-101, and IEC 60870-5-104 Protocol Traffic Monitor for easy troubleshooting, especially during the installation stage. It is worth mentioning that traffic logs can be viewed in the popular troubleshooting tool, Wireshark. With this feature, you can easily analyze traffic to determine the root cause of a problem. Maintenance Functions MGate 5114 gateways support a system log function that records events in the MGate; users can easily review log data remotely through the web console. The gateways also support status monitoring and fault protection functions. The status monitoring function notifies a PSCADA system when a device gets disconnected or does not respond, in which case the PSCADA system gets the status of each end device and then issues alarms to notify operators. 10/100BaseT(X) Ports (RJ45 connector) 2 Auto MDI/MDI-X connection Magnetic Isolation Protection 1.5 kV (built-in) Industrial Protocols Modbus TCP Client (Master), Modbus TCP Server (Slave), IEC 60870-5-104 Client, IEC 60870-5-104 Server Configuration Options Web Console (HTTP/HTTPS), Device Search Utility (DSU), Telnet Console Management ARP, DHCP Client, DNS, HTTP, HTTPS, SMTP, SNMP Trap, SNMPv1/v2c/v3, TCP/IP, Telnet, SSH, UDP, NTP Client MIB RFC1213, RFC1317 Time Management NTP Client Console Port RS-232 (TxD, RxD, GND), 8-pin RJ45 (115200, n, 8, 1) No. of Ports 1 Connector DB9 male Serial Standards RS-232/422/485 Baudrate 50 bps to 921.6 kbps Data Bits 7, 8 Parity Even, Mark, None, Odd, Space Stop Bits 1, 2 Flow Control RTS Toggle (RS-232 only), RTS/CTS RS-485 Data Direction Control ADDC® (automatic data direction control) Pull High/Low Resistor for RS-485 1 kilo-ohm, 150 kilo-ohms Terminator for RS-485 120 ohms Isolation 2 kV (built-in) RS-232 TxD, RxD, RTS, CTS, DTR, DSR, DCD, GND RS-422 Tx+, Tx-, Rx+, Rx-, GND RS-485-2w Data+, Data-, GND RS-485-4w Tx+, Tx-, Rx+, Rx-, GND Industrial Protocols Modbus RTU/ASCII Master, Modbus RTU/ASCII Slave, IEC 60870-5-101 Master (Balanced/Unbalanced), IEC 60870-5-101 Slave (Balanced/Unbalanced) Configuration Options Serial Console Mode Master, Slave Functions Supported 1, 2, 3, 4, 5, 6, 15, 16, 23 Max. No. of Commands 128 Mode Client (Master), Server (Slave) Functions Supported 1, 2, 3, 4, 5, 6, 15, 16, 23 Max. No. of Client Connections 32 Max. No. of Server Connections 32 Max. No. of Commands 128 Mode Client Server Max. No. of Client Connections 32 Max. No. of Server Connections 32 Max. No. of Information Objects 2000 points Mode Master (Balanced/Unbalanced) Slave (Balanced/Unbalanced) Max. No. of Master Connections 1 Max. No. of Slave Connections 1 (Balanced), 31 (Unbalanced) Max. No. of Information Objects 2000 points microSD Slot Up to 32 GB (SD 2.0 compatible) Input Voltage 12 to 48 VDC Input Current 455 mA @ 12 VDC Power Connector Screw-fastened Euroblock terminal Contact Current Rating Resistive load: 2 A @ 30 VDC Housing Metal IP Rating IP30 Dimensions 36 x 105 x 140 mm (1.42 x 4.14 x 5.51 in) Weight 507 g (1.12 lb) Storage Temperature (package included) -40 to 85°C (-40 to 185°F) Ambient Relative Humidity 5 to 95% (non-condensing) Operating Temperature MGate 5114: 0 to 60°C (32 to 140°F) MGate 5114-T: -40 to 75°C (-40 to 167°F) Safety EN 60950-1, UL 508 EMC EN 55032/24 EMI CISPR 32, FCC Part 15B Class B EMS IEC 61000-4-2 ESD: Contact: 8 kV; Air: 15 kV IEC 61000-4-3 RS: 80 MHz to 1 GHz: 10 V/m IEC 61000-4-4 EFT: Power: 4 kV; Signal: 2 kV IEC 61000-4-5 Surge: Power: 2 kV; Signal: 2 kV IEC 61000-4-6 CS: 150 kHz to 80 MHz: 10 V/m; Signal: 10 V/m IEC 61000-4-8 PFMF Hazardous Locations ATEX, Class I Division 2, IECEx Class 1 Division 2, ATEX, and IECEx certifications are underway. Please contact a Moxa sales representative for details. Freefall IEC 60068-2-32 Shock IEC 60068-2-27 Vibration IEC 60068-2-6, IEC 60068-2-64 Time 1,140,815 hrs Standards Telcordia SR332 Warranty Period 5 years